Quick start and installation instructions for SwitchBot Keypad

It takes about 10 minutes to install the SwitchBot Keypad. 

We can use the Screw Kit (Two 3.5 x 25 mm [#6 x 1"] screws, two expansion bolts) to install the Keypad to the wall or use the alignment sticker to attach the Keypad to the wall.

Before installing the Keypad to the wall, we can find a favorable position and hold the Keypad to the wall with our hand. Then try to unlock the SwitchBot Lock via the Keypad. If the Keypad can open the SwitchBot Lock successfully, then this position is acceptable for the Keypad. After all these confirmations, we can drill the hole or attach the sticker to install the Keypad.

Please refer to the guidance in the manual.