a. Remove the end cap of the curtain rail, using a screw driver if necessary.

mceclip0.png

b. Close your curtain. Then detach the last curtain hook and remove the last curtain rail glider.

mceclip1.png

c. Insert the separate Hook into the curtain rail from the end. Pull the Hook towards one side of the rail and tilt it. If the Hook stays inside the rail, proceed to the next step. If you try all  the parts still do not work as expected, please contact our customer support at support@wondertechlabs.com.

mceclip2.png

d. Insert both of the Curtain's Main Body (with one Hook attached) and the separate Hook into the curtain rail from the end and attach the separate Hook back to the Main Body. The SwitchBot LOGO should face your room.

mceclip3.png

e. Put the curtain rail glider back to the rail. Then attach the curtain hook back to the glider.

mceclip4.png

f. Install the end cap back to the curtain rail, using a screw driver if necessary.

mceclip5.png

Comments

0 comments

Article is closed for comments.